On Peck we have all sorts of sharp breaks and turns, and keeping everything set the same way each time seems to keep us from snagging up and still in the fish. We usually run two middle rods at 45 degrees and two outside rods just a bit further back. The thinking on 45 degrees is to keep the BB from tipping over and adjusting the BB weight by the depth. Ive tried both ways at the same time and on that lake the long line will severely out fish the 45 degree line. My home lake is a reservoir and i run my rig 50+ yards behind me ( dont get hung up the name BB ) and have great success. Depending on the bottom you may want to experiment. Many sincere thanks to all that have commented on this thread.ĭont feel that keeping your line at a 45 is law. I posed the question in the original post to find a way to improve the bottom bouncers (with "split ring" style wire bends) that I already have. I am in the process of getting these put in place for next season. I'm quite interested in the pencil style bottom bouncers that hang from a sinker slider. I'm fairly sure that the fouling of the rig was after the hook set. I studied the matter, and am confident that I wasn't letting the bottom bouncer free fall to the bottom of the lake, thus causing the spinner rig to get fouled. These fish put up lively battles on the way to the net.Īfter removing hooks and then re-baiting, I noticed the monofilament of the spinner rig was often wedged into the "split ring" type bend of the wire of the bottom bouncer. None of these walleyes were under about 21 inches, with some of the longer walleyes running about 25 inches or so. I caught around thirty or so walleyes over the span of a little over one hour. I would start in about 25 fow and slowly work my way out to about 28 fow. I was pulling a two hook crawler harness behind the bottom bouncer. I pulled up to a rock hump and decided to use a bottom bouncer rather than vertical jig fish. These bottom bouncers have the "split ring" type of bend in the wire where the main fishing line is attached. I used some of my standard bottom bouncers while on a fishing trip during mid-September to a lake in NW Ontario. I will offer a bit of background for my original post. Many thanks to all that have responded to this post. On the other hand, maybe it is necessary to keep the gap of the "split ring" open to serve as a "spring" when the bottom bouncer is "pogo sticking" along the bottom. Do you do anything to the "split ring" on the bottom bouncer to close the gap? For example, do you close the gap in the "split ring" with a dab of epoxy or maybe solder? It took time to remove the spinner rig from the "split ring". I suspect the bottom bouncer was doing "loop de loops" around the main line and spinner rig during the course of fighting the fish, netting the fish and removing hooks. This bend sort of resembles a split ring.Īfter catching a fish, I frequently noticed that the spinner rig would often be fouled in the "split ring" of the bottom bouncer. The bottom bouncers that I use have a bend in the wire shaft where the main fishing line attaches to the bottom bouncer. I had considerable success when fishing for walleyes with bottom bouncers this summer. I have another question about bottom bouncers that I would like to pose before the Walleye Central fishing community.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |